The quarry dust is used to manufacturing of hollow blocks. The program involves casting and testing cube specimens in each set consisting of 3 cubes. The cubes were casted using standard cubes of 150 mm 150 mm 150 mm. Specific gravity of sand and quarry dust of 2.62 and 2.70. 53 grade cement is used for the mix.
5 P.Bhuvaneshwari An partial replacement of cement by with waste marble powder in -8163 Apr.2015 6 D.suji experimental study on concrete using waste marble powder and quarry dust as partial replacement of cement and fine aggregate ISSN2348-7607. Volume 3 - sep. 2016 Ramya raju partial replacement of cement by
quarry dust dayswhich replaces the cement. In this experimental investigation concrete cubes of 150mm 150mm 150mm were casted and cured for 7,14 amp 28 days conventionally. In this experimental investigation cubes casted with partial replacement of cement by quarry dust with percentages 0, 10, 20, 25, 30, and end up with 40. M30 grade of
Abstract This study presents an experimental investigation on self-compacting concrete SCC with fine aggregate sand replacement of a Quarry Dust QD 0, 25, 50, 75, 100 and addition of mineral admixtures like Fly Ash FA and Silica Fume SF amp chemical admixtures like super plasticizers SP.
This experimental study presents the variation in the strength of concrete when replacing sand by quarry dust from 0 to 100 in steps of 10. M20 and M25 grades of concrete were taken for study keeping a constant slump of 60mm. The compressive strength of concrete cubes at the age of 7 and 28 days were obtained at room temperature. Also the temperature effect on concrete cubes at 100 o C on ...
Experimental Study on Use of Quarry Dust and Fly Ash with Partial Replacement of Fine Aggregates and Cement in Concrete Arfat Saiyad Krunal Prajapati B. E. Student B. E. Student Department of Civil Engineering Department of Civil Engineering A D Patel Institute of Technology, New V V Nagar A D Patel Institute of Technology, New V V Nagar
This present work is an attempt to use Quarry Dust as partial replacement for Sand in concrete. Attempts have been made to study the properties of concrete and to investigate some properties of Quarry Dust the suitability of those properties to enable them to be used as partial replacement materials for sand in concrete.
river sand. Quarry dust and Marble powder contains similar properties as that of river sand and hence accepted as a building material. The present paper focuses on investigating maximum percentage replacement of river sand by Quarry dust and Marble powder in varying equal percentages 0, 10, 20, 30, 40, 50, and 60 for M25 mix designations.
to study the effect of partial replacement of fine aggregates by quarry dust and cement by fly ash on cement concrete. 1.2 NEED FOR INVESTIGATION Quarry Dust These residues are generally less than 1 aggregate production in the normal concrete. The introduction of quarry dust for mixing is limited due to its high fineness.
total or partial replacement of river sand in concrete. For 28 days of curing, partial replacement of fine aggregate with 20- 50 quarry dust content resulted to optimum compressive strength of concrete for several mix ratios and watercement ratios 3,5,10-13. Engineers have also used quarry dust as total replacement of sand in concrete.
Zainab Z. Ismail , Enas A. Al-Hashmi Use of Waste Plastic in Concrete Mixture as Aggregate Replacement 7 Arivalagan.S Experimental Investigation on Partial Replacement of Waste Plastic in Concrete 8 Kshiteesh Gaur1, Jyotsana2, Anil Kumar Arya3, Neelesh Kumar Singh4 Use Of Plastic as Partial Replacement of Fine Aggregate in ...
An Experimental Investigation on Properties of Concrete by Partial Replacement of Cement with GGBS and Fine Aggregate with Quarry Dust Dr. D. V. Prasada Rao, C. S. Mallikarjuna In the present study an investigation is made on properties of concrete by partial replacement of Cement with Ground Granulated Blast Furnace Slag GGBS and Fine ...
investigated the influence of 100 replacement of sand with quarry dust. Initially cement mortar cube was studied with various proportions of quarry dust CM 13, CM 12, and CM 11. The experimental results showed that the addition of quarry dust for a fine to coarse aggregate ratio of 0.6 was found to enhance the compressive properties as ...
Bentonite and Quarry dust can be used as partial replacement with certain percentage. Based on the compression and split tensile strength tests following conclusion can be made. 1 The physical properties of Bentonite and Quarry dust satisfy the requirements of cement and fine aggregate respectively. 2 The compressive strength for 20
An Experimental Investigation on Strengths Characteristics of Concrete with the Partial Replacement of Cement by Marble Powder Dust and Sand by Stone Dust Md Mahboob Ali, Prof. S.M.Hashmi P.G Student of structural Engineering, Department of Civil Engineering, K.B.N College of Engineering, Gulbarga-585104
EXPERIMENTAL INVESTIGATION ON PARTIAL REPLACEMENT OF CEMENT USING MICRO-SILICA Ramesh.J ... In concrete, scientist have found many special type of concrete which they have replaced cement, river sand, gravel and even water. Method of concreting also have changed a lot, but in environmental factors and in strength factors only. ... EXPERIMENTAL ...
Abstract-This paper represents the results of the investigation carried out from the use of saw dust as partial replacement for fine aggregate in concrete.Saw dust is a waste material obtained from woods or otherwise resulting from the machine ... materials called aggregates such as gravel, sand, crushed stone, slag etc. cemented together with ...
Dec 01, 2019 An experimental study on usage of quarry rock dust as partial replacement for sand in concrete Int. J. Adv. Res. Educ. Technol. IJARET , 1 July-September1 2014 Google Scholar
Experimental Investigation of Partial Replacement of Cement with Glass Powder and Eggshell Powder Ash in Concrete Vijayvenkatesh Chandrasekaran, Vasanth M, Thirunavukkarasu S and Manikanda Prabu T Department of Civil Engineering, St. Josephs College of Engineering and Technology, India Submission April 30, 2018 Published June 12, 2018
crushed sand can be mitigated by using a water reducing admixture. R. Ilangovana et al. 6 found that the natural river sand, if replaced by hundred percent quarry rock dust from quarries, may sometimes give equal or better than the reference concrete made with Natural Sand, in terms of compressive and exural strength studies.
Nov 02, 2020 When the partial replacement of sand with marble waste and scoria increased from 33 to 67, the concrete strength for all mix, improved by 27 11.56 MPa, 28.7 12.5 MPa, 24.3 9.94 MPa for the mix 5, mix 6 and mix 7 respectively when compared to the control mix.
Beam-Column Joints in High Performance Concrete Using Metakaolin and Partial Replacement with Quarry Dust G.R.VijayShankar 1 andD.Suji 2 Department of Civil Engineering, Karpagam University, Coimbatore, Tamil Nadu , India Department of Civil Engineering, R.V.S. College of Engineering and Technology, Coimbatore, Tamil Nadu , India
3.4 Quarry Dust The quarry dust used for this investigation work is obtained from the quarry near tindivanam in Tamil Nadu. The quarry dust passing through 4.75 mm retained on 150 micron IS sieves are taken. Specific gravity of 2.617 and fineness modulus of 2.706 has been used. 3.5 Silica Fume The specific gravity of silica fume is 2.2.
Lot of research has been done regarding the crusher dust as alternative materials for river sand. Misra 1984 studied the effect of complete replacement of sand by stone dust in the cement sand mortar cubes. Ahmad et. al. 1989 investigated by replacing sand with crusher sand fine sand i.e. passing through 75 . They found that the
CiteSeerX - Document Details Isaac Councill, Lee Giles, Pradeep Teregowda Metal foundries use large amounts of the metal casting process. Foundries successfully recycle and reuse the sand many times in a foundry and the remaining sand that is termed as foundry sand is removed from foundry. This study presents the information about the civil engineering applications of foundry sand, which is ...
dust also increases. e partial replacement of quarry dust gavea days peakcompressivestrengthatreplacement level. Figure shows that the compressive strength of M 25 27 29 31 33 35 37 39 41 43 0 102030405060 Percentage replacement of quarry dust Compressive strength Nmm 2 M20 and 0.45 M25 and 0.45 M30 and 0.45 M20 and 0.50 M25 and 0.50 M30 ...
presented in TABLE 1. Fig.1 shows sieved quarry dust and Fig.2 shows manual mixing of quarry dust with sand. III. EXPERIMENTAL INVESTIGATION 3.1. Mix Proportion The concrete mix design was proposed by using IS 10262 10. The grade of concrete used was M
4.3 FLEXURAL STRENGTH TEST The experimental investigations after 7 days show that by the partial replacement of sand 40 and addition of steel fibre 1 of cement content the flexural strength increases by 12.90 also when partially replaced
EXPERIMENTAL INVESTIGATION OF COMPRESSIVE STRENGTH ... This study aims at utilization and to ascertain the suitability of saw dust ash as a partial replacement ... Basic materials such as cement, sand, and gravel required for the concrete are to be collected. Cement used in the
present investigation, Partial Replacement of Cement with Fly Ash and Sand with stone quarry dust Used in Concrete by 5, 10, 15, 20 and 30 respectively to produce Concrete. Concrete is tested for Compression, split tension and flexural strengths. The results are quite encouraging for use of fly ash and stone quarry dust in producing Concrete.
2. A Ishaya, A Arinze, Properties of Concrete Produced with Waste Bottle Caps as a Partial Replacement of Coarse Aggregate and Orange Leaves Powder as Plasticizer,Civil and Environmental research , Vol.8, No.7, 2016. 3. 3 .Dr. P. Perumal, G.Balamurugan , Use of quarry dust to replace sand an experimental study,
investigation, an experimental program was carried out to study the workability and compressive strength of concrete made using stone dust as partial replacement of fine aggregate in the range of 10 - 100. M25 grade of concrete was designed using Portland pozzolana cement PPC for referral concrete. Workability and Compressive strength were ...
with partial replacement of ingredients. 40 sand was replaced by crushed stone dust and cement was replaced by fly ash from 0- 40 at increment of 10. Flexure and split tensile tests were conducted in M20 mix using PPC. From the test results it was
Effect of Fly Ash on Mortar Mixes with Quarry Dust as Fine Aggregate. Usage of quarry dust as partial replacement to river sandnatural sand further modified by partial replacement of pozzolanic materials like fly ash is receiving more attention these days as their use generally improves the properties of cementconcrete.
der as partial replacement for cement. In this direction, an exper-imental investigation of compressive strength, split tensile strength, and Flexural strength was undertaken to use egg shell powder and admixtures as partial replacement for cement in con-crete. Keywords---Egg shell powder, cement mortar, Saw dust ash, Fly